Modulo Ky-022 Sensor Receptor Infrarrojo Ir Pic

[mnfisher]

Also note - I power the receiver from pins 4 and 5 - $D4 =1 , $D5 = 0.

LabNation_Screenshot60.png (136.51 KiB) Viewed 437 times

[mnfisher]

What MCU do you want to use for transmit and receive?

[ELECTRONICA67]

PIC12F1840 TX and 16f1847 RX whit crystal de 4 mhz RX

sorry. . . . It took a bit of work and I haven't been able to give it the necessary attention, I managed to do a test with Arduino and the IR control on the laptop monitor but I couldn't receive data

Enrique (in fact it's 2:00 am and I'm barely going to rest)

[mnfisher]

Okay - is the IR remote RC5 or NEC (which is more common)?

The transmitter program has 50% duty on the signal - which might be better reduced slightly (overloads the gain control on the receiver)?

Hope you get a good sleep!