FC - itself 'seems' to offer the ESP32-Camera board - I went with this - but upload doesn't work as is. (Note you need TX->UDR and Rx to UDT, IO0 to Gnd - and need to press reset to init programming (button on the underside of the board which is poor for breadboard work).
Anyway - using a simple blinkie - uploading from FC fails.
I tried uploading from command line. So - going to ProgramName/build and then pasting the FC command line - this needs -z adding
This works - and pulling the IO0-Gnd jumper and resetting bkinkie works okay.esptool.py -p COM7 -b 115200 --before default_reset --after hard_reset --chip esp32 write_flash -z --flash_mode dio --flash_freq 80m --flash_size 4MB 0x8000 partition_table/partition-table.bin 0x1000 bootloader/bootloader.bin 0x10000 esp-project.bin
Anyone any ideas why this shouldn't / might not be okay. I'll add to a new config file and have some more play...
Edit - with in0 grounded pressing reset enters the bootloader. After the jumper to in0 is removed - press reset again to run the program.
Martin