Flowcode6 for PIC, DMX Slave component problems

[teeseetwo]

Hi Ben

Well, you were right, there might be a small fault in the memory of this particular chip causing the warning message. Turning off "Verify After" in the programmer allowed the programming to complete and the DMX decoding now works. Great ! The only question I have is whether there is any hope to get the DMX Slave component in Flowcode 6 to work ? If not I will have to upgrade to FC9, but in the interests of saving £££ it would be nice to have the FC6 version working. Is there anything that I could do to achieve that, maybe some timing adjustments within the component ?

Thanks for all your help
Regards
Tony