This is really a request for suggestions. Anything that works out of the box would be appreciated.
Is there a combination of a commercial ESP32 and touch screen components that has been proven to work in Flowcode 9? I suppose I could try the esp support in Arduino IDE and move the display module back to Flowcode 9 as c or macros?
V9 Touch screen that works off-the-shelf
-
kdoney34711
- Posts: 7
- http://meble-kuchenne.info.pl
- Joined: Wed Apr 14, 2021 2:33 am
-
stefan.erni
- Valued Contributor
- Posts: 997
- Joined: Wed Dec 02, 2020 10:53 am
- Has thanked: 190 times
- Been thanked: 217 times
Re: V9 Touch screen that works off-the-shelf
Hi kdoney
There is a Modul with touchscreen and can be programmed with FC9.
https://flowcode.co.uk/forums/viewtopic.php?f=3&t=287
regards
Stefan
There is a Modul with touchscreen and can be programmed with FC9.
It's not proved and still some (little) problems but it's good to look at it.that has been proven to work in Flowcode 9
https://flowcode.co.uk/forums/viewtopic.php?f=3&t=287
regards
Stefan
-
mnfisher
- Valued Contributor
- Posts: 1453
- Joined: Wed Dec 09, 2020 9:37 pm
- Has thanked: 135 times
- Been thanked: 707 times
Re: V9 Touch screen that works off-the-shelf
Nextion displays provide a powerful, easy to use and 'self-contained' option.
They communicate with the MCU via a UART.
They are available in a range of sizes and 'capabilities' - see https://nextion.tech/intelligent-series-introduction/
Martin
They communicate with the MCU via a UART.
They are available in a range of sizes and 'capabilities' - see https://nextion.tech/intelligent-series-introduction/
Martin