Hello. Programs cannot be loaded to some clone Arduino nanos. I have 3 Arduino Nanos. Two of them are FT232 and one is ch340 integrated. All three Arduino nanos are solid. Because I can program with the Arduino ide. However, with flowcode, I can send a program to one of the two Arduinos with FT232 chips without any problems. But I cannot assign programs to the other two Arduinos. It gives the following errors. I tried all the solutions on the forum regarding the issue to no avail.
Please don’t post hard to read pictures. In there should be a .msg file in the same folder your flowchart is stored that contains the messages. Please either attach that or include it in a [ code ] - [ /code ] block. (Skip the spaces after/before the brackets)
From my experience with Clone Nanos and they are brilliant for the price but usually come with either no firmware or wrong firmware. If you have a working Uno handy then you can load this with the ISP firmware and then use it as a tool to load the bootloader onto the Nano devices.
Flowcode admins, this problem is important and needs to be solved!
1- It works on 3 Arduino nanos. Two of the nanos are FT232 and one is with a CH340 chip. Because with Arduino ideas, programs can be uploaded to all three without any problems.
2-The program is installed on one of the FT232 devices without any problems. It is not loaded on the other two.
3-In the flowcode of the question, there are two separate options: Arduino nano 328 and Arduino nano 328 115200. It is not available in the free version with Arduino 328 115200. I think the problem comes from here. What's the difference between the two options?
It sounds like Flowcode is correctly producing the HEX file, but the programmer being used (AvrDude) and/or the hardware connection tot he device is the problem. You could try loading the HEX file using an alternative programmer.
As the problem does not appear to be due to Flowcode, there is not much else we can suggest.