It is possible to add a transmission module GSM based on the NEOWAY M590. I have a kit based on it and on the development board in addition to the usual vcc and 5v there are pins with the names I T V K G
If it was possible...
Thank you.
selozerouno.
Module GSM M590 kit for Arduino and other chip.....
-
- Posts: 113
- http://meble-kuchenne.info.pl
- Joined: Tue Dec 08, 2020 4:36 am
- Has thanked: 2 times
- Been thanked: 2 times
-
- Matrix Staff
- Posts: 1738
- Joined: Mon Dec 07, 2020 10:06 am
- Has thanked: 439 times
- Been thanked: 603 times
Re: Module GSM M590 kit for Arduino and other chip.....
Hello,
It looks like this module should work as is with our existing GSM component.
Though I'm not sure about the IO markings on the board you have, the chip datasheet seems to have the standard TX/RX UART interface.
Do you have a link to the board you have so we can see if there is any additional information on it?
It looks like this module should work as is with our existing GSM component.
Though I'm not sure about the IO markings on the board you have, the chip datasheet seems to have the standard TX/RX UART interface.
Do you have a link to the board you have so we can see if there is any additional information on it?
Regards Ben Rowland - MatrixTSL
Flowcode Online Code Viewer (Beta) - Flowcode Product Page - Flowcode Help Wiki - My YouTube Channel
Flowcode Online Code Viewer (Beta) - Flowcode Product Page - Flowcode Help Wiki - My YouTube Channel