Max7219_v9

[Amtor]

Hello
Just wondering if anyone else has had this happen.
I've been using Martin Fisher great component and it works lovely, it's a fantastic piece of work.
The only problem I'm having, is the connection settings never save, it always defaults back to the attached.
It's not a major problem just wondering what would cause that to happen.
Thanks for any info.
Mark

[Steve-Matrix]

Please post a (preferably simple) project that shows this problem and we will have a look.

[Amtor]

Thanks.
I notice its only the A18,A23,A22 that does not save the rest of the settings save.
It changes the setting back to B1,A14,A13
The A5 saves ok.

[chipfryer27]

Hi

I think I've seen something similar. When I open a previous chart pins seemed to have changed. Couldn't say for certain though.

Maybe in a similar vain to this ? viewtopic.php?p=14350#p14350

Regards

[jgu1]

Hi all!

Dare to come in

Same issue with the Touch component Xpt2046

Not save the pinconnection

Jorgen

[medelec35]

Hi.
Thanks for the report.
We will see if we can sort this issue out.

[Amtor]

I tried the Touch component Xpt2046
and it saved for me in channel mode but not when set for software.
Settings on the max7219 get greyed out in channel mode.
It's all a mystery to me.
I'm half senile I think

[Steve-Matrix]

Settings on the max7219 get greyed out in channel mode.

I don't have that component - it is not an official one.

Same issue with the Touch component Xpt2046

I have been able to replicate the issue with this one and will look into it.

[jgu1]

Thank you Steve

[Steve-Matrix]

I think I've discovered the cause of the problem. Unfortunately it requires changing a low-level component that I am not familiar with. I have passed on the details and hopefully this can get sorted soon.