Suggestions for new microcontroller support

[SpeedPIC32]

PIC18F27Q84
PIC18F47Q84
PIC18F57Q84
28/40/44/48-Pin, Low-Power, High-Performance
Microcontroller with XLP Technology
The PIC18-Q84 microcontroller family is available in 28/40/44/48-pin devices for many automotive and
industrial applications. The many communication peripherals found in the product family, such as Controller
Area Network (CAN), Serial Peripheral Interface (SPI), Inter-Integrated Circuit (I2C), and two Universal
Asynchronous Receiver Transmitters (UARTs), can handle a wide range of wired and wireless (using
external modules) communication protocols for intelligent applications. Combined with the Core Independent
Peripherals (CIPs) integration capabilities, this capacity enables functions for motor control, power supply,
sensor, signal and user interface applications. Additionally, this family includes a 12-bit Analog-to-Digital
Converter (ADC) with Computation and Context Switching extensions for automated signal analysis to reduce
the complexity of the application.

[kapila_chandramouli]

Any plans to support the recent Raspberry Pi Pico 2 / RP2350 board/chip family? If so what's the timeline?

Thanks,
Kapila

[DirkB]

Hello Martin,

I have removed the midi component from my PIC18F15Q41 test to see if the compiler runs without errors.
Unfortunately there is an error message.

::: error: (1504) the PIC18 extended instruction set was enabled but is not supported by this compiler
(908) exit status = 1

Where can I switch it on and off? Where can I switch it on and off? I have not switched it on. And can I expect
the PIC18F04/05/06 - 14/15/16Q41 family to be ready soon?

Thanks

Dirk

[medelec35]

Hi Dirk,
To prevent the Suggestions for new microcontroller support being hijacked,
can post all correspondence regarding PIC18F15Q41 to here

[prasha920]

Hi,

I'm working on project where i need to use 18F47Q43 controller. Currently it is not available in list. May i know when it can be available as I don't want to change the controller.

[medelec35]

Hello I have moved your post to a more appropriate section of the forums.
Thank your suggestion, it has been added to the list.