ESP32S3 Mini-1 as target

[stefan.erni]

Hi Ben

Would it be possible to add an ESP32s3 mini-1 as a target?
It has more pins.

esp32-s3-mini-1_mini-1u_datasheet_en.pdf

(1.28 MiB) Downloaded 138 times

Current selection from FC11 ESP32s3 mini does not have all the necessary ports and pins:

2026-03-06_14-32-29.PNG (65.01 KiB) Viewed 1710 times

This is, for example, on the
Adafruit ESP32-S3 Reverse TFT Feather

5691 ESP32 S3 Reverse TFT Feather.jpg (68.5 KiB) Viewed 1710 times

adafruit_products_schem.png (159.41 KiB) Viewed 1710 times

https://learn.adafruit.com/esp32-s3-re ... t-feather

[BenR]

Hi Stefan,

Great spot thanks for letting us know, should be sorted for you now.

[stefan.erni]

Hi Ben

Perfect!

I was able to connect all the pins and it works in the simulation.
I will test it with the hardware soon.

[stefan.erni]

Hi Ben

One more question.
The ESP32S3 Mini has 3 UARTs.
Can you add the third one?

2026-03-13_12-06-33.PNG (56.42 KiB) Viewed 327 times

[stefan.erni]

Hi Ben

Here's another small issue
For me, the most important thing is that UART0 is mapped to GPIO 43 (TX) and GPIO 44 (RX).

Maybe it's just a graphics issue with the PIN number:

2026-03-13_14-25-26.PNG (33.19 KiB) Viewed 316 times

2026-03-13_14-34-05.PNG (122.37 KiB) Viewed 316 times