Hello together
I would like to read a NOX sensor from Continental.
This works with the CANopen protocol.
I would like to use an ESP32-Wroom-32D chip for this.
For the coupling there are ready MCP2515 Can Bus controller shield board module For arduino. or a PIC32MZ.
It would be nice if it could work.
With kind regards
CANopen
-
SpeedPIC32
- Posts: 261
- http://meble-kuchenne.info.pl
- Joined: Thu Dec 10, 2020 2:35 pm
- Has thanked: 36 times
- Been thanked: 17 times
-
SpeedPIC32
- Posts: 261
- Joined: Thu Dec 10, 2020 2:35 pm
- Has thanked: 36 times
- Been thanked: 17 times
-
BenR
- Matrix Staff
- Posts: 1926
- Joined: Mon Dec 07, 2020 10:06 am
- Has thanked: 501 times
- Been thanked: 684 times
Re: CANopen
Hello,
CAN Open is quite involved, we've looked at it before and there is a fair amount of work to allow the stack to function. I've made a note to have another investigation into it as it certainly would be nice to have.
CAN Open is quite involved, we've looked at it before and there is a fair amount of work to allow the stack to function. I've made a note to have another investigation into it as it certainly would be nice to have.
Regards Ben Rowland - MatrixTSL
Flowcode Online Code Viewer (Beta) - Flowcode Product Page - Flowcode Help Wiki - My YouTube Channel
Flowcode Online Code Viewer (Beta) - Flowcode Product Page - Flowcode Help Wiki - My YouTube Channel
-
SpeedPIC32
- Posts: 261
- Joined: Thu Dec 10, 2020 2:35 pm
- Has thanked: 36 times
- Been thanked: 17 times
Re: CANopen
Hello Ben,
what about the Can-Bus?
I can provide you with everything.
E.g. a Can-Bus shield from Sparkfun.
A NOX sensor with description from Continental.
All pre-wired with power supply.
What do you think of that?
I would like to be able to read out the sensor data, the NOX value and the oxygen content.
With best regards
what about the Can-Bus?
I can provide you with everything.
E.g. a Can-Bus shield from Sparkfun.
A NOX sensor with description from Continental.
All pre-wired with power supply.
What do you think of that?
I would like to be able to read out the sensor data, the NOX value and the oxygen content.
With best regards