Exercise - Importing the LED Component: Difference between revisions
No edit summary |
No edit summary |
||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
<sidebar>Sidebar: | <sidebar>Sidebar: Flowcode Exercises:Ex3</sidebar> | ||
[[File:gen_exerciseimportmacro_compmacroprops.png|300px|right]] | [[File:gen_exerciseimportmacro_compmacroprops.png|300px|right]] | ||
* [[Creating Flowcharts|Create a new flowchart]]. | * [[Creating Flowcharts|Create a new flowchart]]. | ||
| Line 10: | Line 10: | ||
== | ==What next?== | ||
Create a flowchart which uses the imported component, and then [[Exercise - Testing an Imported LED Component|test the imported component]] in simulation to ensure it works properly | Create a flowchart which uses the imported component, and then [[Exercise - Testing an Imported LED Component|test the imported component]] in simulation to ensure it works properly | ||
Latest revision as of 14:44, 13 March 2014
<sidebar>Sidebar: Flowcode Exercises:Ex3</sidebar>
- The following assumes that you have built, and exported a LED component, as described in Exercise - Create an LED Component and Exercise - Exporting the LED Component.
- Open the 'Outputs' toolbox, where you stored the exported 'newLED' component. (If no destination was specified for the exported component, it would appear in the 'Misc' toolbox.)
- Locate the 'newLED' component, and use the down-arrow next to it to add it to the System Panel. It can now be used in the same way as any other electronic device.
What next?
Create a flowchart which uses the imported component, and then test the imported component in simulation to ensure it works properly